Homeslice - Just Like a Boss

SIP Firmware Load on Cisco 7965G First Step is to get the firmware from 3CX Then follow these steps: When SCCP is loaded:     Complete the following steps:     Unplug the power cable from the phone, hold dows the # key, and     then plug the power cable in again.     The phone begins its power up cycle.     Release the # key after the Speaker button is no longer     lit.     You should see the following message on the phone:     "Reset key sequence detected"     Press 123456789*0# within 60 seconds after the Headset, Mute,     and Speaker buttons begin to flash.     If you enter this key sequence correctly, the phone displays     this prompt:     Keep network cfg? 1 = yes 2 = no     In order to maintain the current network configuration settings     for the phone when the phone resets, press 1. In order to r...

Cisco 3560 switch Password Reset and Recovery Procedure 3560 password recovery enabled procedures Before you start you will need a Cisco console cable, which has a DB9 and RJ45 on the other end, plug in the RJ45 to the Console port on your cisco, then plug in the DB9 to a USB-serial converter such as the TripLite USA-19HS , use Putty to connect to serial, usually the speed is 9600 or 19200 baud, N,8,1 Pull the power cord.  Now plug it back in, then Push the green button in front, while plugging in power, then hold it down while Cisco starts up, You will see a message on your console window indicating that you are in password recovery mode. Let go of the button. type this for password recovery. switch: flash_init switch: load_helper switch: rename flash:config.text flash:config.old switch: boot after the switch boots and you are at the enable prompt, type this: switch# rename flash:config.old flash:config.text Switch# copy flash:config.text syst...